Search Results for ‘bracket’

Hello fellow forum family.. My name is David ..I have a 2007 Mitsubishi Eclipse GS ... Love the car ...BUT been a money pit...I'm now looking for and JUST a ...Rear Transmission mount " BRACKET " 2.4 , 4 cylinder, automatic ... Dealership told me it was just tranny mount WRONGO...And Mitsubishi...

After reading the manual and what I could find here, I've come to the conclusion that either i'm retarded or i'm missing something. But in the process I found it a whole lot easier to just remove the 6 bolts holding it down, push it up as far as it goes. than you can access the lower bolt on the...

Hey guys, On our ‘06 GS, we’re doing the front brakes over. On the backing plates (aka splash shields, dust shields, etc) there are the two main bolts that go through it (brake caliper bracket bolts). No problem there. But there is one small 10mm bolt as well, which of course immediate broke...

Boy, I got the crap scared out of me recently! I was at work out of state when my wife messaged me and told me that our 17 y.o. son was at a local fast food joint in the Eclipse when it made a terrible noise under the hood and wouldn't run. Of course, my first thought was the timing belt had...

Sorry if this is in the wrong section but I was wondering if there was a list somewhere of the bolt sizes on our cars. Not the head size to remove the bolt but the thread and pitch to get new ones. I'm going to be doing the rear sway bar soon and was wondering the bracket bolt size. We only have...

Are there any differences between the front license plate brackets on the different years and models for our car? I keep seeing just one eclipse-specific one that's good for 06-08 (through production date 2/22/08) but I have no idea if my car fits in that date (as an 08). To my untrained eye...

Well, my folks bought me a backup camera for Christmas and my Dad and I installed it. I apologize for not taking any pics of the install. The process: Trying to find a switched power source was interesting. We ended up tapping into the radio sw/power. -removed the rear trunk inner plastic...

So, as you may or may not know, Brian J developed a module several years back that allows people with automatics to use the steering wheel audio control buttons as "paddle shifters", in the sense that you would use the buttons to change gears, rather than the stock center console shifter. I...

Hey guys! Took me a little time to figure this out. I am using a radio similar to this one; https://www.amazon.com/Developed-1024x600-Bluetooth-Navigation-Receiver/dp/B01M8M4S39/ref=sr_1_3?ie=UTF8&qid=1483821470&sr=8-3&keywords=joying With the MITO 01 adapter for my factory RF sound system...

Step 1: Remove the door panel. There are guides on here about how to remove it, and I will link one in the bottom of this post. It's basically two bolts and four screws. The bolts are 10 mm. Step 2: Cut off the plastic rivets. There are three on the passenger door and four on the driver door...

In spanish for best expressions! Que tal amigos, pues el día de ayer por primera vez lo lleve a la pista local, con árbol de luces y esta fue mi experiencia. La pista opera con un tiempo limite inferior de 9 segundos, debido a que la zona de frenado no supera los 800 metros, en total la pista...

I purchased a set of solid aluminum replacement door panels on ebay which I'm sure come from someone on this forum and I wanted to post my thoughts after installing them. The handles on my car were beginning to break and I decided that I wanted to replace them with something that wouldn't. I...

Diy or pay a machine shop $25. Get stiff! This was acquired from a previous member on an older post.

I'm swapping out my blown 2.4l and cant remember the configuration of the shifter cable bracket that mounts on top of the transaxle, anyone have a pic.

I bought the hardware from Mitsubishi thinking it was for the air dams aka fangs. Got the box and it ended up being hardware to install the SE front lip. Still worked though, just didn't use the middle bracket with the rivets. Just thought I'd upload the Mitsubishi instructions. Hardware kit...

Hey everyone! I think this has been covered, but I couldnt find it. Hopefully others find this useful... I know most of the time trouble code P0442 is most likely a leaky gas cap, but in my case, I've been through 4 diff gas caps, and finally found my real problem. I inspected all the lines...

I decided to move my license plate off the front and center of the nose to down in the bottom right grill area, but now I'm left with a problem. The dealership drilled 3 large holes in the nose of the car for the plate bracket, and I want them gone. What's your guy's thoughts on filling them...

Only a few things are available. Car had 88xxx miles on it. Frost White - Exterior A Pillar (Passenger Side) - $70 shipped SOLD Frost White - Exterior A Pillar (Driver Side) - $70 shipped SOLD Light Gray - Front Leather Seats (POWER/HEATED DRIVERS) - $300 + Shipping SOLD RF Sub w/ bracket -...

so its been a couple of week since i started my supercharger instilation , its taking forever due to some fabrication and other things that I wont annoy you with as you can see the bracket is on , and the blower , the injectors (440 RC) had to get rid of the front frame to fit my intercooler...

I'm a big guy and absolutely in love with my '07 Spyder GT. I drive it every day to and from work and am fortunate to live in an area right in the middle of 3 of the 5 fastest highways in the US - and I use them often, for hours on end. Every weekend I spend at least 3-4 hours just adventuring...