Search Results for ‘screw’

I want to upgrade to ES poly bushings, but ride quality and (mostly) cost are a concern. Is it possible to just replace the front control arm bushings and leave the backs OE rubber? Would that screw with handling/alignment? Has anyone done just front (or rear) only?

Recently bought an '06 GT - didn't try the air until it got hot - no air. Pump was not engaging - all lights were coming on. Found a small brass valve on top of the AC pump that was stuck open. It looks almost like a needle/seat from a carb. Pressure safety shut off? Not sure but I took...

I am having a problem replacing my clutch fluid. I followed the Shop Manual instructions and I can't seem to get the new fluid to go into the Master Clutch Cylinder. The manual says, open the bleeding screw, hold the clutch pedal down, close the bleeding screw, release the clutch pedal and then...

As I am searching through the car I am finding out that the previous person that owned the car either did some work on the car or a mechanic forgot to put screws back in certain places. I've been on e-bay trying to use their diagram to find the specific screws I am missing but have had no luck...

Hello, I need sunroof motor screw (part number 5850A085). But, as it turned out it's discontinued and no one sells it. Sunroof did not work, previous owner said he removed the fuse because it can freeze during winters over here. Turned out, motor is missing entirely. I managed to buy used...

I’ve recently replaced my bulb to an LED H13. I want to align them since they aim to low. I’ve searched around the forum and went and look by the frame through the hole, but no screw exists. Where is it? 09 Eclipse GS

Hey! So I know there's a lot of material out there on how to properly bleed your clutch, but I decided to make a guide since me and the shop that worked on my car made some stupid mistakes on it. So! While I'm doing this on a 2.4, I assume the process is the same for the 3.8. If your clutch...

When you get under the car and unscrew the magnetic bolt, How much liquid drops out of the system? the manual says 2.1qt's but the car definitely dropped more than that. >.>

Hey everyone. I was at the track tonight, and it ended pretty badly for someone there. He tried to take a corner too fast on his motorcycle, ate a wall, and got hit by a car doing about 120mph. I want to throw it out there, that even though it seems so obvious, stay safe. If you don't think...

Hey Guys... Happy to say I have finally purchased one of the Eclipse Alloy fuel doors and can't wait to receive it. My car is black in color and I have red Badges and painted my calipers red. My strock rims are painted black as well. To stick to this uniform look... I would like to paint my new...

Screw finding winter tires in 235/45R18's Only ones i could find were goodyears for ~$190 Sent from my VS995 using Tapatalk

Hey guys so Ive been on the forums for a couple of years but ive never had the nuts to post a pic of my car since it was a POS when I bought it. Heres a little background of how i got the car and what my build was about So I got my 07 Eclipse GS back in '13 with 48,000 miles. I paid a...

Hey guys! Took me a little time to figure this out. I am using a radio similar to this one; https://www.amazon.com/Developed-1024x600-Bluetooth-Navigation-Receiver/dp/B01M8M4S39/ref=sr_1_3?ie=UTF8&qid=1483821470&sr=8-3&keywords=joying With the MITO 01 adapter for my factory RF sound system...

hello friends, after a mechanical repair my engine vibrated, check the bottom and two screws were missing. the screws are probably part 1 or 9. someone can help me with the size and dimensions of the screws. Engine hanger screws 🙏🙏

Alright, I have searched but couldn't find the answer to my question. I just installed headers and have an extra slot which is plugged with a bolt. However, I would like to install a wideband and wondered if there was anything that I could screw into that hole without having to weld? The...

Ever since I bought my car, the cap covering the screw behind the driver's side interior door handle has been missing. I'm considering hydro dipping the area behind the handle, so I've been looking for a replacement. The part number is 5716A154HA, and it is called a handle bezel cap. This part...

So today went from being a fun day of install some new HID high beams to a nightmare (Projector lenses, 2 bulbs) This is what I'm looking for some opinions on Does anybody know if all of that happens to be on the same fuse for some stupid reason? And just for fun... Other problems: 1 LED...

Hello, Every one on the forum am new here this is my first post and i wish it wan't a problem with my car but maybe some can help me. I got a 2007 mitsubishi eclipse GS so Last night i was driving home when i can upon my exit off the high way i speed up and took the exit with high speed...

Gonna be taking my car to the drive in, and plan to set up camp in the trunk with the hatch open. Problem is, with the hatch open the lights come on. Does anyone have a simple way to disable that? Eg, to screw with the switching mechanism. Otherwise I'm gonna have to pull the bulbs

Hi there, I am new to club4g and thought I'd introduce myself. My name is Tyler, I'm 24 and just bought a silver 2006 Eclipse GT that has 94,000 miles on it completely stock other than having tinted glass and hid wiring that doesn't quite work so just have oem lights in right now. Will post some...