Search Results for ‘stalling’

Has anyone purchased the surtrack cv axles for automatic transmission? I did an when I got them I was already iffy about installing them because the factory axles are double the weight of the surtrack axles but I went ahead an installed them an now feel some heavy vibration, I only drove around...

I am in the process of installing fog lights on my eclipse, and I bought an aftermarket switch. The OEM fog light harness has four colors on it: light blue, black with dots, black with yellow stripe and green with white stripe. Does anyone know what each wire does, so I can splice it into the...

I've been thinking about installing a new axle-back for my 2011 Eclipse GS Sport. I've looked at recommendations from various posts on club4g but most people recommend Road Race Engineering and they only have the "Road Race Axle Back Exhaust 2006-2008", not anything for a 2011 GS dual exhaust...

Alright so my hood latch broke last week, and I am unable to find a replacement anywhere that ships to Canada. Was wondering on people's thoughts of installing Locking hood pins in its place. Hood is the OEM steel hood not a carbon fiber or Fiberglass.

Hey guys, first post so I hope I'm in the right spot. All videos and posts I've seen show the black/red/white aux pins installed in a 22 pin connector. However, my connector is a 10 pin. And instead of holding down the CD button to select aux, I must hold down Channel 1 and press the power...

I'm looking to order Shocks & Struts for my 2008 Eclipse Spyder GT. I usually use RockAuto when ordering parts. When looking at these products I found both Front Struts and Rear Shocks, but the fronts did not come with the coil that I see when looking at my vehicle. I'm wondering if anyone could...

Hey guys, I need help installing a fan controller on my 2008 Eclipse GT. Has anyone ever done this? If so, what do I need to do this job? Do I have to cut wires from my radiator fan?

The Dodge Stratus Coupe and Chrysler Sebring were based on the 3G Mitsubishi Eclipse platform. In this video I'll be swapping out the stock driveline in favor of an AWD system with an automatic transmission from an EVO GTA, while installing a turbocharged 4G63 engine from a Mitsubishi Evolution...

Does anyone have the resistance value to get the airbag light to turn off? I'm installing a fixed back seat and need to trick the ecu into thinking it is plugged in. The car has two active codes that will not turn off until they're plugged in. It's not a matter of 'going to the dealer' or...

Hello to all, Here is my set up: 2009 Spyder V6 Injen cold air inteke OBX long headers. Finally installing my AEM computer (from BrianJ) add an to the Spyder. Anyone have a basic setup i can use? Thanks Peter

My first post, getting involved with removing and reinstalling all top cylinders for 2007 Spyder. Can someone direct me to the correct thread or should I start a new one? Regards, Pikecoman

I'm thinking of installing a cold air intake in my Mitsubishi Eclipse 2009 GS(Automatic). What is the best and economical cold air intake I can buy for it? Anything else I should take care of when installing a cold air intake? Thanks in advance! :hail:

Lately after filling my tank the car has difficulty starting. I have to crank it for several seconds before it starts and even then it sputters and I have to keep my foot on the gas to stop the engine from stalling. The problem goes away after a while of driving but happens every time I fill up...

Hi all. Yesterday while installing my exhaust at a friends house, his dad (also a mechanic and someone who does AC stuff on cars and industrial units) helped me find the leak in my AC system. The question is, what part is this? My friend said that it is likely an "O Ring" but if that's the...

Hey Guys..... I have a sweet double DIN deck, amp and 15" subwoofer thats been collecting dust for a few years now. I need to either get this installed or sell it.... and am leaning towards installing. I installed systems in my old Cobalt and sunfire many moons ago, but for this install, since...

So it's been suggested to me by more than one person to forgo installing the LW flywheel and go instead for an OEM. Problem with that is they're very expensive (~$800). After a little digging, I came upon the Luk brand and see that they make drivetrain parts for our cars, including dual mass...

Just got a 2007 Eclipse GT with 121,500 about a week ago. Ran across Club4g while looking for a fix to the Cruise Control that was not working, and, the "TCL OFF" and "Antilock" lights coming on in the instrument panel. Found the fix here on Club4g by installing the necessary resistors for the...

I live in Columbus Ohio and I was hoping maybe another member lives in Columbus or in Ohio who has had their ECU reflashed after installing a cutback and headers on their car. Thanks So far no luck with two local places

Well car is on hold. For now last night i found out my water heater had cracked around the pressure release valve at some point and has been leaking for a while. So had to drop money i dont have into a water heater and redoing my water lines which broke uninstalling the water heater. And the...

Hi All, Looking to replace the radiator on an 06 GS with manual trans and wanted to see if the procedure below sounds about right. EDITED to cover what actually was done now that job was completed.(may have missed something as doing from memory) Remove negative battery cable! Chock rear...