Mitsubishi Eclipse 4G Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've seen and followed the few videos I have found on removing trans and replacing the clutch but I need specs for the bell bolts top and bottom? Anymore related to transmission assembly would help...
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #2 ·
I have used this site for removing everything down to the engine but I need those torque specs cause I hate the thoughts of breaking bolts or my engine falling apart.. Someone help a fellow 4g owner! Its an 07 gt 3.8 spyder and its been sitting for a week already... She just wants to go fast again
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #4 ·
So I saw the manual before also. Those bell bolts on the trans to the engine were a pain to get off...were they really only suppose to be 9 ft lbs?
 

·
Basically Stock
2009 GS Turbo. 2007 GT
Joined
·
6,664 Posts
So I saw the manual before also. Those bell bolts on the trans to the engine were a pain to get off...were they really only suppose to be 9 ft lbs?
I see 65ft lbs for the "coupling bolt" in the "tightening specifications" in sections 22A page 24

By the size of the bolts, and threading into iron, 60-70 sounds about right anyway
 
1 - 5 of 5 Posts
Top